MARQUIP 1850MM SYNCHRO SHEETER + UNWIND STANDS FOR 6 WEBS

The machine installation comprises of the following equipment.

The sheeter was made in 2016

UNWIND STAND

1850mm Marquip V Double sided stands x 3 units

For up to 6 reels when paper thickness is considered.

Max Roll Width  1850mm; Min Roll Width 450mm

Max Roll Diameter 1830mm; Min Roll Diameter  470mm

Max Roll Weight 3410 Kgs

Torque Activated Step Chucks  76 – 152mm  (3 to 6”) per roll 6 units

Unwind Web Clamp  6 units

Manual Reel Trolley  Low Profile  6 units

Roll Diameter Sensing Web Tension Control – Single Web  -  6 units

Motorised Roll/Edge Decurler  1900mm   6 unis

Overhead Web Support Rolls

Web Aligner for 6 webs

Operators Side Platform

Back Stop Catwalk

Tidland Class III Manual Setup

Digital Readout System for Assisted Anvil Positioning  1

Trim Removal Nozzles – Mounted to Slide with Clamps  1

Trim Removal Fingers with Air Assisted Trim Deflectors  1

Cuttinghead – 1850mm  Dual Rotary Knife (Synchro Sheeter)

Cut length Accuracy  +/- 0.4mm

Knife Loading  1000 GSM Under knife

Machine Max Speed -  300 MPM

Practical Production Speeds are a function of material basis weight, stiffness, surface finish, caliper, consistency, sheet size, number of webs at a time, environmental conditions, general machine conditions, knowledge of operator..

Cut Quality depends on paper thickness, coatings and knife set up for optimum cut.

Multi Web  of up to 700mm in total of 6 reels.

Squareness 0.06mm of the sheet width.

Moisture Content  5 to 8%

Splice detectors and Auto Reject gate

First and overlap conveyors with Vacuum Box for high speed  sheet control and overlapping.

Pile up (Jam) Detectors at strategic locations on the sheeter

Tapes Over Stack for pile control

Semi Auto Pallet Changer

Tab Inserter – 3 units

Line Control Software with Backup Copy

Sheeter General Specification:

Operating Temperature Range  5 to 40 Degree C   (41 to 105 degree F)

Relative Humidity  20 to 95%